MightyMount Switch™
With an identical hole pattern as old school deck mounts this mount can be used to switch to a deck mount that accommodates modern track accessories without the need to drill more holes.
Compatible with the YakAttack LockNLoad™ mounting system and with other MightyBolt accessories. For kayaks with pre-threaded inserts, additional hardware may be required.
Instructions for Inflatable Kayaks:
- Locate the red bag of hardware containing nuts, washers, and LONG screws and discard them. They will not be used for inflatable kayak installs.
- Position the MightyMount Switch on your YakAttack SwitchPad or other inflatable mounts.
- Locate the SHORT 1/4-20 x 5/8" long stainless screws in the bag labeled, “Hardware for Inflatable Installs.”
- Put a dab of Loctite on the threads and insert a SHORT screw into each hole of the MightyMount Switch.
- Hand tighten with a Phillips Screwdriver until snug. Repeat steps 3 and 4 for the rest of the hardware.
- After all screws are installed, fully tighten, being careful not to over tighten.
Instructions for Rotomolded and ABS Kayaks:
- Locate the Hardware for Deck Mount Installs
- Position the MightyMount Switch on the surface where you want to install it.
- Using a hole in the MightyMount Switch as a guide, drill the first hole using a 17/64” drill bit.
- Drop a LONG 1/4‐20 screw through the MightyMount Switch and into the drilled hole. This will prevent the MightyMount Switch from sliding around as other holes are drilled.
- Repeat steps 2 and 3 for the rest of the holes.
- Once all holes are drilled, remove all screws.
- Apply marine sealant as desired into hole and/or on screw threads.
- Install first screw with washer and nut on inside of hull, but do not fully tighten.
- Repeat steps 6 and 7 for remainder of screws.
- After all screws are installed, fully tighten, being careful not to over tighten.
Your Satisfaction with YakAttack is Guaranteed:
- Free Shipping on Orders Over $49
- Lowest Price Guaranteed
- Covered by YakAttack's Built for Life Guarantee
